Adtec EN-20, Руководство пользователя

Страница: 14 / 49

America) channel plan will return a
value of ( -1 ) in the channel field,
however, the RF output frequency
will be as entered. Valid range of
frequencies is 57 to 861MHz
inclusive.
Note:
​
If using API Commands, you must specify which encoder the command applies to by
substituting '0' (for Encoder 1) or '1' (for Encoder 2) in place of the '#' symbol in the
commands above. For more information, see the "API Commands" article in this manual.
QAM Configurations are global configurations that will automatically be applied when
configuration is sent to either encoder.
IP Tx Menu
The following diagram represents the structure of the
​
IP Tx Menu
​
Menu:
Control/Settin
g Function Options API Command
Mode switches multicast function on and
off Off
Send *.ECMD0 MMO
#
Tx IP Address The IP Address of which the
Multicast or Unicast is broadcast.
Multicast addressing supports the
transmission of a single IP
datagram to multiple receivers.
Valid Multicast addressing range is
224.10.XXX.XXX to
239.XXX.XXX.XXX. Unicast
addressing sends a single IP
datagram to only one receiver.
The Unicast address will be the
unique IP of the receiving device. user-defined;
numeric field
in format
xxx.xxx.xxx.x
xx *.ECMD0 MSI #
Tx Port Port assignment used for
transmitting a multicast user-defined;
numeric field *.ECMD0 MSP #
DVB per IP Configures the amount of DVB
transport stream packets ( 188
bytes per DVB packet ) per IP
packet payload.
1
4
7
*.ECMD0 MSY #
RTP Allows for sequence numbering
and timing for accurate playback. On
Off *.ECMD0 RTP #