Industrial PCs OPC6012/6015
10
© ads-tec GmbH • Heinrich-Hertz-Str. 1 • D-72622 Nürtingen
2
O
PERATING INSTRUCTIONS
This device contains electrical voltages and extremely sensitive components. The
manufacturer, or a service partner authorised by the manufacturer, should be consulted if
you plan to make any modifications. For this type of work, the device must be switched off
at the mains and the power lead must be disconnected. Suitable measures for avoiding
electrostatic discharge towards parts of the components when touching the equipment
must be taken. If the device is opened by an unauthorised person, hazards for the user
might arise and any warranty claim will cease.
General instructions:
All users must read this manual and have access to it at all times.
Installation, commissioning and operation may only be carried out by trained and
qualified staff.
The security instructions and the manual itself must be observed by all persons
who work with this device.
At the location of use the valid guidelines and regulations for accident prevention
must be observed.
The manual contains the most important instructions on how to use this device in a
safe way.
Appropriate storage, proper transport, installation and commissioning, as well as
careful operation are prerequisites for ensuring safe and proper operation of the
device.
The device can be cleaned by using a soft cloth and a commercially available
glass cleaning agent (e.g. Sidolin) with low alcohol content.
Warning:
Any leads (e.g. power leads, interface cables) may only be connected if the device
is switched off in order to avoid damaging the device.
2.1
O
PERATING LOCATION
The control system is designed for use inside a switching cabinet. You must ensure
compliance with the specified environmental conditions. Using the device in non-specified
environments, for example on board ships, or in areas that might contain explosive gases,
or in extreme heights is prohibited.
Warning:
The device may only be switched on after acclimatising to the ambient temperature in
order to avoid condensate accumulation. The same applies if the device has previously
been exposed to extreme temperature variations.
To avoid overheating in operation: The device must not be exposed to direct
radiation by sunlight or any other light or heat source.
Pos : 12 /D atent ec hni k/Betri ebs hi nweis e/ Sc häden durch uns achg emäß en G ebrauc h/Schäden durc h unsac hgemäß en G ebr auch @ 0\ mod_1158827867958_6. doc @ 221 @
2.2
D
AMAGE DUE TO IMPROPER USE
If the control system shows any obvious damage, e.g. caused by improper operating or
storage conditions or by improper use or handling, you must immediately put the device out
of operation and protect it from being accidentally switched on.
Pos : 13 /D atent ec hni k/Betri ebs hi nweis e/ Gewährleist ung / R eparatur/ G ewährleist ung / R epar at ur @ 0\ mod_1158828054427_6. doc @ 223 @
2.3
W
ARRANTY
/
REPAIR
During the warranty period, any repair must be carried out by the manufacturer or by
persons duly authorised by the manufacturer only.
Pos : 14 /D atent ec hni k/Betri ebs hi nweis e/ Behandlung und Ents orgung von Lithi um-Batt erien/ Behandlung und Ents orgung von Lithi um-Batt erien @ 1\ mod_1247056308470_6.doc @ 5922 @
