Adp 40000 Series, Руководство по установке

Страница: 16 / 18

Installing the Backup Battery Option
12 ADP, Inc.
Note
If you are in the process of installing the Series 4000 timeclock, return to the Series 4000
Badge Timeclock Installation Guide and continue with “Installing the Transformer” in
Chapter 2. If you are adding or replacing the battery in your installed timeclock, continue
with this procedure.
7. Install the transformer back into the timeclock. To do this:
a. Position the transformer back in place behind the wire transformer clip. Ensure that
the end of the transformer with the permanently attached cable is facing down.
b. Route the transformer cable (cable coming from the bottom of the transformer)
back to its connection on the main board, inside the cover of the timeclock.
c. Connect the transformer cable to the main board.
d. Plug the power cord into the top of the transformer.
8. Connect the battery charger board to the timeclock’s main board. See the following
illustration.
9. Plug the transformer into the AC power source.
10. After the timeclock powers up, close and lock the timeclock’s cover, using the security
wrench to tighten the security screw on the right side of the timeclock.
Number Description
1 Battery charger board cable that connects to the main board
2 Charger board connection to the main board