Adkins Beta Swift, Руководство оператора

Страница: 12 / 23

Page 8
3. How to Operate the Beta
Swift
3.1
Starting with the Beta Swift
3.1.1 Plug into your supply outlet and switch supply on.
N.B. Please ensure the mains plug is easily accessible to the
operator so that in the event of a fault the machine can be
unplugged.
3.1.2 Turn on the Beta Swift; the on/off switch is to the right of the
controller. When the set temperature is steady in the display
the machine is ready to use.
3.2 Applying Adkins Laundry Labels
3.2.1 The Beta Swift Heat Press is pre-set with a temperature of
200ºC and a time of 12 sec. (A label is affixed to the front of
the press with these settings)
N.B.
If either of the above is not the case
please refer to Page 13 -
Control Unit Operation, and programme using the settings
above
3.2.2 Place the garment on the pressure pad, removing all wrinkles.
3.2.3
Place the label in the desired position.
3.2.4
Using both hands gently pull the handle forward into the
locked position, ensuring the work piece is firmly clamped
between the heat plate and pressure pad.
3.2.5
When the pre-set dwell time has been reached, a buzzer will
sound. The heat plate should then be lifted by pushing the
handle back to its full extent, again using both hands.
3.2.6
For safety reasons, it is necessary to push the handle into the
locked position after it is lifted. This will ensure the accidental
lowering of the heat platen handle.
3.3 Pressing Pad Assembly
The pressing pad normally supplied with this machine is silicone