11
SETUP
Power Supply: The ADJ WiFly EXR HEX5 IP contains an automatic voltage switch, which will auto-
matically sense the voltage when it is plugged into the power source. With this switch there is no
need to worry about the correct power voltage, and this unit can be plugged in anywhere.
DMX-512: DMX is short for Digital Multiplex. This is a universal protocol used as a form of commu-
nication between intelligent fixtures and controllers. A DMX controller sends DMX data instructions
from the controller to the fixture. DMX data is sent as serial data that travels from fixture to fixture
via the DATA “IN” and DATA “OUT” XLR terminals located on all DMX fixtures (most controllers only
have a DATA “OUT” terminal).
DMX Linking: DMX is a language allowing all makes and models of different manufacturers to be
linked together and operate from a single controller, as long as all fixtures and the controller are DMX
compliant. When linking several DMX fixtures, try to use the shortest cable path possible in order
to ensure proper DMX data transmission. The order in which fixtures are connected in a DMX line
does not influence the DMX addressing. For example, a fixture assigned a DMX address of 1 may be
placed anywhere in a DMX line: at the beginning, at the end, or anywhere in the middle. When a fix-
ture is assigned a DMX address of 1, the DMX controller knows to send DATA assigned to address 1
to that unit, no matter where it is located in the DMX chain.
DMX Cable Requirements: The WiFly EXR HEX5 IP can be controlled via DMX-512 protocol.
The WiFly EXR HEX5 IP has 5 DMX channel modes (see the DMX Traits section of this manual for
detailed information). The DMX address is set on the back panel of the WiFly EXR HEX5 IP.
Cable Requirements: This fixture is designed with special cables for both DMX and power. These
cables are specifically designed to maintain the integrity of the IP rating. When using this fixture for
outdoor applications, be sure to ONLY use the ADJ cables that have been manufactured to meet the
IP rating.
“First” DMX Cables - A special DMX “First” cable (part #WIF901-DMX Cable) may be purchased
from ADJ to provide a means of data communication with standard DMX fixtures for indoor use.
These cables will come with the IP rated twist lock connector on one end and either a 3-pin XLR
male or female connector on the other, depending on model. Be sure to only use these cables for
intergrading this fixture in a standard DMX chain.
“First” Power Cable – A special power “First” cable is included with every fixture. This cable is used
to provide power to your fixture. This cable comes with the IP rated twist lock connector on one end
and a standard 3-prong, grounded connector on the other end. Be sure to only use this cable for
power distribution. Never attempt to connect this cable to the DMX lines.
You can chain multiple fixtures together through serial linking using the IP rated signal cables pro-
vided through ADJ (part# WIF901-Power Cable). Always be sure to daisy-chain your in and out data
connections, and never split or “Y” your DMX connections unless you are using an approved DMX
splitter, such as the ADJ WiFly D6 Branch or the original D6 Branch (both units not IP rated).
