ADJ Products, LLC www.adj.com - RGBW4C IR Page 14
RGBW4C IR ADJ LED RC2 Control
• Color Macros Mode - When the controller is set to Color Macros
mode, the LED above the button will glow. Press the “+” & “-” but-
tons to find your desired static color. Press the SPEED button to
enter fade speed adjustment, and use the “+” & “-” buttons to ad-
just the fade speed. Press the SET ADDR button and use the “+” &
“-” buttons adjust the Master Dimmer. Press the W button and use
the “+” & “-” buttons to adjust the White intensity.
• Chase Mode - When the controller is set to Chase mode, the LED
above the button will glow. Press the SPEED button, and use the
“+” & “-” buttons to adjust the chase speed. Press the SPEED
button twice to enter fade speed adjustment, and use the “+” & “-”
buttons to adjust the fade speed. Press the SET ADDR button and
use the “+” & “-” buttons adjust the Master Dimmer. Press the W
button and use the “+” & “-” buttons to adjust the White intensity.
• Manual RGBW Color Mode - When the controller is set to
Manual RGBW Color mode, the LED above the button will glow.
Press the R/G/B/W buttons, and use the “+” & “-” buttons to ad-
just each colors output intensity.
SOUND ACTIVE MODE
-
Press the SL/SA button to activate Sound
Active mode. The LED above the button will glow indicating that your
are in Sound Active mode. Use the SOUND SENSITIVITY dial on the
reare of the unit to adjust the sound sensitivity. Press the SPEED but-
ton to enter fade speed adjustment, and use the “+” & “-” buttons to
adjust the fade speed. Press the SET ADDR button and use the “+”
& “-” buttons adjust the Master Dimmer. Press the W button and use
the “+” & “-” buttons to adjust the White intensity.
PRESET MODE
-
In any working mode, press the A button, then
press and hold either of the 1, 2, or 3 buttons for more then 3 seconds
to save that scene to the corresponding PRESET button on the con-
troller. If your save was successful all PRESET button LEDs will flash
3 times. To recall the scene press the 0 button then press the number
button where your desired scene is located.
Example: Press the A button, then press the #2 button for more then
3 seconds to save the scene to PRESET button 2. If the save was suc-
cessful all PRESET button LEDs will flash 3 times. To recall the scene
in PRESET button 2, press the 0 button, then press the #2 button.
FLASH
-
Press this button to activate the strobing. The LED above the
button will glow indicating that strobing is active. You can control the
flash rate by pressing the “+” and “-” buttons. Press this button again
to deactivate strobing.
RGBW4C IR ADJ LED RC2 Control
ADJ Products, LLC www.adj.com - RGBW4C IR Page 15
