RGBW4C IR
Chase Chart
BUTTONS IN COLORS/CHASES REGION CHASE MODE DESCRIPTION
RED button
Red/Green chase
ORANGE button
Green/Blue chase
YELLOW button
Red/Blue chase
GREEN button
Red/Cyan chase
CYAN button
Green/Purple chase
BLUE button
Yellow/Blue chase
PURPLE button
Red/Green/Blue/Yellow/Purple/Cyan/White
chase
MAGENTA button
Red/Green/Blue/Red/Blue/
Yellow
/Cyan/
Yellow chase
WHITE button
Yellow/Purple chase
ADJ Products, LLC www.adj.com - RGBW4C IR Page 12
ADJ Products, LLC www.adj.com - RGBW4C IR Page 13
RGBW4C IR Operation
2. Press any of the 9 color buttons or use the RGBW faders to make
your own desired color.
3. Use the faders (10, 11, 12, & 13) to adjust the LED intensities.
Preset Mode: Using these buttons you are able to save and recall a
chase, color, or program.
1. To save a chase, color, or program, press 1 of the 3 PRESET but-
ton for at least 3 seconds. When all of the LEDs flash 3 times, this
informs you that the save was successful.
2. To recall the saved chase, color, or program, press the correspond-
ing PRESET button.
RGBW4C IR ADJ LED RC2 Control
The
ADJ LED RC2
infrared remote has many differnet functions
that can help you control your
RGBW4C IR. To control the RGBW4C
IR, plug the included IR receiver into IR receiver input located on the
rear of the controller. You must aim the remote at the IR sensor and
be no more the 30 feet away.
DMX MODE -
This button will let you select which fixtures to control.
Press this button and then use buttons 1-8 to select your desired
fixtures. The LED above the FIXTURE buttons that you have selected
will light up when you have chosen that fixture.
Example: Press the DMX MODE button, then press the #7 button. The
LED above FIXTURE button #7 will light up. You are now controlling
fixture #7. Press the #7 button again deactivate control of fixture #7.
BLACKOUT
-
Pressing this button will blackout any fixture(s) being
controlled at the time. When blackout is active, the LED above the
BLACKOUT button will flash. Press the button again to deactivate
blackout.
SELECT PROG
-
Pressing this button will cycle among RGBW Fade
mode, Auto Run mode, Color Macros mode, Chase mode, and
Manual RGBW dimmer mode. Each press of the button will switch to
the next mode.
• RGBW Fade Mode - When the controller is set to RGBW Fade
mode, the LED above the button will glow. Press the SPEED button,
and use the “+” & “-” buttons to adjust the program running speed
Press the SPEED button twice to enter fade speed adjustment,
and use the “+” & “-” buttons to adjust the fade speed. Press the
SET ADDR button and use the “+” & “-” buttons adjust the Master
Dimmer. Press the W button and use the “+” & “-” buttons to ad-
just the White intensity.
• Auto Run Mode - When the controller is set to Auto Run mode,
the LED above the button will glow. Press the SPEED button, and
use the “+” & “-” buttons to adjust the program running speed.
Press the SPEED button twice to enter fade speed adjustment,
and use the “+” & “-” buttons to adjust the fade speed. Press the
SET ADDR button and use the “+” & “-” buttons adjust the Master
Dimmer. Press the W button and use the “+” & “-” buttons to ad
just the White intensity.
