2012-03-29 Manual Q-8V100 and S-25A30 Rev. 0.1
preliminary
23
6.6.3. White balance (color only)
In color cameras, a gain per channel (R, G, B) is available.
Command Syntax:
WBr;g;b
WB?
r, g and b are the gains per channel R, G and B in steps of 0.01x, ranging from 100 to 400.
6.6.4. Output look-up table
In the camera an output look-up table (OLUT) can be applied.
When the table is programmed in the camera, it can be enabled by:
Command Syntax:
OLUTEx
OLUTE?
With x=0 the OLUT is disabled, with x=1 it is enabled.
The table can be programmed by the following sequence of commands:
Command Syntax:
OLUTBGN
OLUTx
0
OLUTx
1
⁞
OLUTx
1023
OLUTEND
x
0
to x
1023
are the values of the OLUT, each ranging from 0 to 1023.
If not 1024 OLUT values are entered, the OLUT will not be programmed.
Down scaling to 8 bit output is done after the OLUT stage.
An OLUT value can be queried by the command OLUT?i with i the index.
6.7. Output format and Camera Link settings
6.7.1. Region of interest
Within the sensor resolution of 5120x5120 a ROI may be applied.
Command Syntax:
ROIx;y;w;h
ROI?
x and y are offset of the left top position of the ROI with respect to the left top origin of the
sensor resolution (= 0,0).
w and h are the ROI width and height.
x, y, w and h are in pixels.
x must be a multiple of 2 and ranges from 0 to 5119.
y can be any value between 0 and 5088.
