2012-03-29 Manual Q-8V100 and S-25A30 Rev. 0.1
preliminary
11
Figure 3.3: I/O-interface schematic
A current of 2.5 mA is recommended for the Flash strobe output. For the Trigger input, a
current of 10 mA is recommended. These current recommendations translate to the
recommended series resistor values in table 3.4.
Recommended series resistor (2.5 mA flash strobe; 10 mA trigger input):
Vext [V]
R1E [
Ω]
R2
E [Ω]
3.3
1000
Do not apply
5.0
2000
0
12
4700
470
3.2. Camera Link interface connector
The Camera Link interface is designed to connect the camera to a frame grabber in order to
transfer video to the grabber as well as control data from the grabber to the camera. The
maximum cable length is 10 meter, for a 85MHz interface however 5 meter is recommended.
For a description of the Camera Link interface please refer to the Camera Link specification.
NOTE:
PoCL (Power over Camera Link) is not supported. When connecting the camera to a
PoCLcompliant frame grabber, the PoCL-function must be disabled.
NOTE:
The Q-8V100 and S-25A30 support only Camera Link 8 tap and 10 tap configuration.
This requires two equivalent cables (i.e. of the same length and preferably the same brand
and type number).
Interface connectors: 3M MDR 26-pins.
Standard Camera Link cables can be ordered at Adimec.
