9
Never charge a GEL battery with a non suitable recharger. Strictly
follow the instructions supplied by the batteries and recharger
manufacturer.
In order not to cause permanent damages to the batteries, it is
necessary to avoid their complete discharge, providing for the
recharging within a few minutes after that the batteries discharge
signal starts blinking.
NOTE: Never leave the batteries completely discharged even if the
machine is not used. In case of traditional batteries, please check the
electrolyte level every 20 recharging cycles and eventually top them up
with distilled water. Never leave the batteries discharged for more than
two weeks.
Danger of gas exhalations and emission of corrosive liquids. Fire
danger: do not approach with free flames.
CONNECTING THE BATT. CONNECTORS AND SWITCHING ON OF
THE MACHINE
Once that the battery recharging has been completed:
1.
Disconnect the connector of the battery recharger from the
battery connector (1).
2.
Connect then the battery connector (1) to the machine connector
(2).
3.
To start any function of the machine, it is necessary to rotate
clockwise the key switch (5). Rotating it counterclockwise any
function will be switched off.
BATTERY CHARGE LEVEL
When the machine is switched on, on the display (1) appear in order the
following information:
1.
the version (for example A003) of software installed on the
machine.
2.
the setting of the battery check card which can be:
3.
GE 36: check card set for GEL batteries.
or
4.
Pb 36: check card set for lead batteries.
5.
The batteries charge level indicator is digital and remains fixed on
the display. The battery charge level starts from 100, which
indicates the 100% of the total charge and decreases from 10 to
10. When the charge level reaches 20%, the display starts blinking,
so you are about the end of working.
After a few seconds of the indication 10% and after this, the blinking
of the four lines, all the functions stop automatically. With the
remaining charge it is anyhow possible to finish the drying operation
before proceeding to the recharge.
HOURMETER
The machine is equipped with an hour meter located on the same
display (1) of the battery charge level indicator. Pressing the button (2),
the first data indicates the working hours and after a few seconds the
working minutes are shown.
SQUEEGEE ASSEMBLY
1.
Insert the two stud bolts (2) situated on the upper part of the
squeegee (3) inside the slots present on the support (1).
2.
To block the squeegee tighten the stud bolts (2).
3.
Insert the squeegee hose (4) into its coupling, respecting its
position as indicated in the figure.
Содержание diamond 100 AC
Страница 1: ...diamond 100 AC diamond 130 03 2019 Use and maintenance Warning Please read the instructions before use...
Страница 2: ......
Страница 19: ......