Industrial
Electronic Devices
ADFweb.com S.r.l.
User Manual
PROFIBUS Master
/ MQTT
Document code: MN67950_ENG Revision 1.000 Page 25 of 36
M
ODULE
P
ARAMETERS
:
The section “Module Parameters” is used to
modify the parameters of the Modules (Fig.
11).
In this section there are:
The List of all Module selected in the
GSD file (“Available modules”) (Fig.
11, point (1));
The List of all Parameters available
for the Module selected (“Parameters
of module”) (Fig. 11, point (2));
The Configuration of all parameters
in RAW for the Module selected
(“Parameters in RAW (Hex)”) (Fig.
11, point(3));
The admited value for the selected
parameter. It is possible to select the
value desired and confirm it with the
“
Apply
” button. If no value appears
in this table, the “Min Value” and
“Max Value” are the limit of the
parameter. (Fig. 11, point(4));
The “
Apply
” button is used to
confirm the new value of the
parameter, the “
Default
” button is
used to load the factory value for the
parameter. In “
New Value
” edit box
it is possible to set the new value.
(Fig. 11, point(5)).
Figure 11: “PROFIBUS Device – Module Parameters” window
