Never operating in a low rotation speed for
long time, otherwise it will cause overheat inside the
machine.
To start the tool, simply pull the switch trigger and keep it
pressed. Tool speed can be variably adjusted depending
on how far the switch trigger is pressed. Release the
switch trigger to switch off the tool. (Fig. 5)
Reversing Switch Action
CAUTION:
Always check the direction of rotation before operation.
Operate the reversing switch only after the tool comes to a complete stop. Changing the direction
of rotation before the tool stops may damage the tool.
When not operating the tool, always set the reversing switch lever to the center position.
Never force to pull the switch trigger while the reversing switch lever is set at the center position.
Right/Clockwise Rotation
Depress the reversing switch lever from side B to side A
for clockwise rotation for drilling and driving in screws
(view forwards).(Fig. 6)
Left/Counterclockwise Rotation
Depress the reversing switch lever from side A to side B
for counterclockwise rotation for loosening or
unscrewing screws. (Fig 6)
Installing or Removing Tools
The tool here includes driver bit, drill bit, etc, which differs from the concept of power tools or
machines.
CAUTION:
Before installing or removing the driver bit or drill
bit, always disconnect the battery from the tool
or set the reversing switch lever to the center
position. Never press switch trigger.
Please pull the bit along the arrow direction after
installing and be sure to fix the bit in the sleeve.
To install the bit, pull the locking cover along the
arrow direction and insert the bit to the inner most
of the sleeve, then loosen the sleeve to fix the bit.
(Fig. 7)
To remove the bit, pull the locking cover and pull
out the bit along the arrow direction. (Fig. 8)
Tightening and Moving Screw
CAUTION:
Make sure that the driver bit is inserted straight in
the screw head, or the screw and/or bit may be
damaged.
Make sure that the reversing switch lever is in the
position of counterclockwise rotation when
moving screw.
To tighten screw, place the point of the driver bit
in the screw head and apply pressure to the tool. Start the tool slowly and then increase the
speed gradually. Release the switch trigger as soon as the clutch cuts in. To move screw,
release the switch trigger as soon as the clutch pulls out. (Fig. 9)
Содержание MAC AFRIC SDRILC-007
Страница 1: ......
