ADEMCO 7845CZ, Инструкция по установке и настройке

Страница: 36 / 64

7845CZ Installation and Setup Guide
5–10
Question 46.
2CS Zone 5 (Y/N)
Press [Y] to enable reporting to second central station for
zone 5.
Press [N] to disable reporting.
Question 47.
2CS Zone 6 (Y/N)
Press [Y] to enable reporting to second central station for
zone 6.
Press [N] to disable reporting.
Question 48.
2CS Zone 7 (Y/N)
Press [Y] to enable reporting to second central station for
zone 7.
Press [N] to disable reporting.
Question 49.
2CS Tamper (Y/N)
Press [Y] to enable tamper reporting to second central
station.
Press [N] to disable reporting.
Question 50.
2CS Sys Rpt (Y/N)
Press [Y] to enable reporting of system report to second
central station.
Press [N] to disable reporting.
Question 51.
2nd City
Enter the secondary city code 2-digit ID (01-99 decimal).
This ID number combined with the CS ID and the
Subscriber ID must be different from the ones
programmed in Questions 1 through 3 (Primary Account
Information).
Question 52.
2nd CS ID
Enter the second central station's system ID number, 01-
FE. This ID number combined with the City ID and the
Subscriber ID must be different from the ones
programmed in Questions 1 through 3 (Primary Account
Information).
Question 53.
2nd Sub ID #
Enter the4-digit customer account number for the second
central station, 0001-9999. This ID number combined with
the City ID and the CS ID, must be different from the ones
programmed in Questions 2 through 4 (Primary Account
Information).
Reviewing Programming Entries
When the last question is answered, the system validates all entries. If no errors are found,
the following is displayed:
REVIEW?
To review the programming options (to ensure that the correct responses have been made),
press [Y]. The programming questions are displayed again, starting with Question 1. Use
the up/down arrow keys to scroll through the program fields without changing any of the
values. If a value requires change, simply type in the correct value. When the last field is
displayed, the “REVIEW?” question again appears.
Setting Factory Defaults
Reset the programming options to factory-default values by pressing [ESC] at the
“REVIEW?” prompt. A confirmation prompt appears. Press [Y] to reset, or press [N] to cancel
this function. If you press [Y], all programmed values are reset to the original factory
settings.
Exiting Programming Mode
To exit the programming mode, press [N] in response to the “REVIEW?” question.