ADEMCO 7845CZ, Инструкция по установке и настройке

Страница: 11 / 64

2–1
S E C T I O N 2
Quick Start Installation Guide
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
BEFORE PROCEEDING ANY FURTHER
- Verify that there is MicroBurst
Coverage in the area in which this unit is to be installed by either checking the coverage
selection at the AlarmNet web site
www.ADEMCO.com/alarmnet
or by calling our technical
assistance group at 1-800-222-6525. The ZIP code of the given installation site must be
known in order to determine MicroBurst availability.
1. Unpack and Initialize the Radio
•
Unpack the 7845CZ and install the antenna.
•
Remove the cover (refer to the “Removing the Cover” paragraph in Section 4).
•
Connect a fully-charged battery (ADEMCO K4362) or apply 12VDC power to TB1 from
either a control panel or a 7720V2TR. Be sure to observe the polarity.
•
Monitor the initial power-up LED sequence (refer to the “Initial Power-Up Sequence”
paragraph in Section 4). This can take several minutes.
2. Find Coverage and Select a Site
IT’S ALL ABOUT COVERAGE!!! -
To be successful using this product,
you must carefully observe service availability, signal strength, and transmission
ability!
•
Verify MicroBurst
coverage using the radio status LEDs as
shown at right, or use the “B” command on the 7720P
Programming Tool (refer to Table 1, Section 2 for a listing of all
7720P Programming Tool keyboard commands and their
function).
•
Choose the installation site with the
best signal strength
by
observing the signal strength (RSSI) bar graph or use the “B”
command on the 7720P Programming Tool (refer to the “Selecting a
Radio Installation Site” paragraph in Section 4 for details).
•
3. Test the Site
•
Test communication with the AlarmNet C and cellular networks by
double-clicking the tamper/test switch and receiving message
validation. If desired, you can cancel validation by clicking the
tamper switch once.
•
If multiple (3 or more) failures to transmit occur (as indicated by the RED Status LED
rapidly blinking after each transmission), the location selected may be inadequate. Move
the 7845CZ to a different location and retest.
off blink rapid
blink
on
LED Key
G
Y
R
MicroBurst
MicroBurst
G
Y
R
G
Y
R
"click"
"click"
"click"
VALIDATION
VALIDATION
3 bars min
R S S I
Y G G G Y