PDK-13010-v.6.0 Edge VS5010 and VS5051 User manual
page 9
The Edge terminal provides extensive feedback via its LED indicators, which
have a flash range from 1 to 5 as shown in the table below. These are used
to report status locally and to allow the installer to install the terminal
correctly so it can signal to the AddSecure Connect platform.
LED
OFF
Flicker on
(Trouble)
Flashing
(Trouble)
On
(Good)
Flicker off
(Good)
Panel
No panel
(or not
enabled)
Panel fault
(check call
overdue)
Panel OK,
SIP test fault
Panel OK,
SIP test OK
Panel and sip
test OK,
Dial port activity
Power
No battery
fitted
(or not
enabled)
Battery fault
Battery low
(limited run
time)
Battery OK
Battery OK,
charging if
power,
discharging if no
power
Cellular
No
connection
(or not
enabled)
SIM card
registered
Internet
accessible
Cellular
polling
Polling OK,
data activity
Ethernet
No
connection
(or not
enabled)
Local
connection
Internet
accessible
Ethernet OK
Polling OK,
data activity
System
No power
System fault
System OK
9
Configuration of the voice panels
For details about the configuration of specific voice panels and alarms,
please refer to the relevant manufacturer’s documentation on their
websites.
Note:
Voice panels shall be installed in accordance with EU directive
2014/33 and with EN81 regulations.
10
Commissioning test
VS5010 terminals do not require manual programming when sited in an
elevator environment. All required information for configuration will have
been provided when the AddSecure Subscription Application webform was
completed. To ensure settings have been correctly downloaded please
check the status of the LEDs on the lid of the terminal enclosure.
LEDs
Meaning
Panel
ON
Power
ON (Short blip shows charging ok)
Cellular Path
ON (Short blips when sending Data)
Ethernet Path
OFF (Not Enabled)
System
ON
If LEDs do not have these states after installation, please contact your local
AddSecure Support team for assistance.
100/0
90/10
0
50/50
0/100
10/90
