page 8
PDK-13010-v.6.0 Edge VS5010 and VS5051 User manual
⑪
Vout3, Power
This connection has 12 V output. It can, for example, be
used for the Call Connect.
A suitable emergency light and buzzer are available from AddSecure on
request.
7.8
Powering up the terminal
The terminal is now installed, so the power supply can now be connected.
Switch the power on and check that the indicator “SYS LED” is flashing (top
green LED on PCBA). If it does not, you need to contact AddSecure.
8
Configuring the terminal
The terminal does not need to be configured. All the configuration and
activation is done by AddSecure directly to the unit.
8.1
Checking signal strength
A good signal, at least 2 LEDs lit, is required in order to activate the terminal. To
see the current signal strength, press and hold the alarm button for at least five
seconds. The five LEDs will respond together, as a bar graph, to indicate the
signal strength. For example:
Low
Medium
Excellent
Cellular signal
strength
When a Reflash is occurring, all the LEDs flash whilst the Reflash is
downloading and then stay on constantly during the re-programming.
