ADB SOFTLUX, Инструкция по эксплуатации

Страница: 7 / 16

Manual - page 7
I s s u e : 0 0 3
SOFTLUX
Cool Lights
Lighting Technologies
3. lamp Replacement
iMpoRtAnt
ALWAYS ISOLATE FROM THE MAINS SUPPLY
BEFORE COMMENCING LAMP REPLACEMENT.
important note
If the unit is switched on with a faulty lamp, or without one or
more lamp in place, the internal ballast will shut down and then
re-set after about 30 seconds.
The plastic lamp supports, which are fitted to the main reflector,
are designed to prevent a lamp from unclipping while in use.
damage may result if a lamp is removed from this support
with the base of the lamp fitted into its end holder.
To remove a lamp, leave the lamp fitted into the lamp support clip , and using minimum force,
pull the lamp from its end holder by sliding it through the lamp support clip. With the lamp base
clear, the lamp can be easily taken off its support clip by rotating it slightly away from the centre
of the reflector while at the same time pulling it out of the plastic support clip.
Reverse this procedure to fit a new lamp.
4. Fuse Replacement (All types)
This luminaire is fitted with a mains protection fuse.
This is located in the IEC22 type power inlet located on the rear of the luminaire.
The fuse is housed in the rectangular panel on the lower edge of the socket.
This can be pulled out by inserting your finger nail under the clip and lifting the fuse holder towards
you. The fuse holder is permanently attached to the power socket.
Slide the fuse out of the holder and replace with a 5 x 20 mm HRC 2 Amp - 250 V fuse.
Replacement fuses should only be fitted of the same type as that fitted at manufacture.