ADB Safegate RELIANCE Shallow Base, Руководство пользователя

Страница: 27 / 46

Electrical connections Base 12” and Base 8”-135-3-X-X (with side
access, partially threaded holes)
Image examples
A Connector Kit, separately supplied, is required to install a
connector on a shallow base. The kit includes:
•
An FAA Secondary Rece Wires (A).
•
A Compression Packer with:
•
one rubber gasket (B)
•
one washer (C)
•
one nut (D)
1.
Install the FAA Secondary Rece Wires from the kit
(A).
From the inside of the base, feed the two wires through
the threaded hole of the base (E).
2.
From the outside of the base, feed the two wires of the
connector through the rubber gasket (B) and place it
inside the threaded hole of the base.
Note
Allow approximately 35 cm secondary cable inside
a 12" base respectively 25 cm inside a 8" base.
3.
From the outside of the base, feed the two wires of the
connector through the washer (C) and place it inside the
threaded hole of the base.
From the outside of the base, feed the two wires of the
connector through the nut (D) on and fasten it in the
threaded hole of the base.
Fasten the nut in the threaded hole of the base; there is
no torque for cable gland as it is fastened onto rubber.
Note
For bases with two connectors, repeat these steps
to install a second connector.
Shallow bases with side access are supplied with two
threaded holes. Shallow bases supplied with only one
connector require the second hole to be plugged with an
Obstruction Cap.
Note
An Obstruction Cap Kit is ordered separately.
4.
Install an obstruction cap (F). From the outside of the
base, position the obstruction cap in the threaded hole of
the base.
5. Fasten the obstruction cap in the threaded hole of the
base.
UM-0106, Rev. 1.0, 2019/12/19 17
Copyright
©
ADB Safegate, All Rights Reserved