ADB Safegate REIL-L, Руководство пользователя

Страница: 33 / 60

•
L-849 E (Three-Step) (see Figure 10 )
•
Changing from a 1-step setting to a 3-step setting:
•
Press the CURRENT ADJUST button SET LOW, SET MED and SET HIGH buttons simultaneously for 4 seconds. The LOW,
MED, and HIGH LEDs will blink for 2 seconds and then turn off.
•
Set the constant current regulator (CCR) to the highest step setting where Low intensity REIL operation is desired.
•
On the LED REIL control board, 44A7338, in the Primary Unit, turn the rotary switch to the ‘Remote’ position. Press and
hold the SET LOW Switch SW2 for 4 seconds. The ‘Low’ LED D18 will flash.
•
Set the CCR to the highest step setting where Medium intensity REIL operation is desired. Press and hold the SET
MEDIUM Switch SW3 on the Flasher Control Board for 4 seconds. The ‘Med’ LED D19 will flash.
•
Set the CCR to the highest step setting where High intensity REIL operation is desired. Press and hold the SET HIGH
Switch SW4 on the Flasher Control Board for 4 seconds. The ‘High’ LED D20 will flash.
•
Set the CCR to the LOW intensity setting, verify that the LOW LED D18 is lit.
•
Set the CCR to the MEDIUM intensity setting, verify that the MEDIUM LED D19 is lit.
•
Set the CCR to the HIGH intensity setting, verify that the HIGH LED D20 is lit.
•
Set the CCR to the desired intensity setting, verify that the desired intensity LED Dxx is lit.
Note
Only the primary unit is programmed. The secondary unit must not be programmed.
96A0461, Rev. H, 2019/10/31 23
Copyright
©
ADB Safegate, All Rights Reserved