ADB Safegate REIL-L, Руководство пользователя

Страница: 31 / 60

Refer to the guidelines below when checking out wiring.
•
All grounding connections to equipment, housing, structures, and ground rods shall be thoroughly checked. The ground
resistance of all ground rods shall be within the limits specified in project plans and specifications.
Warning
All power should be off while resistance checks are being made. A potential of 240 Vac may be present, which can be
lethal.
•
All power and control wiring shall be carefully and thoroughly verified. Using an ohmmeter, check all wires to make sure
that proper connections are made.
CAUTION
If the system is turned on and wiring is connected improperly, all or part of the system can be damaged and void the
warranty.
Connector, Plug, and Jack Checkout
Carefully check all plug and jack connections, and other wiring disconnects for proper mating. Check all terminal board
connections for tightness.
3.15 Safety Switch Checkout
Check the Primary and Secondary cabinets and flash heads for complete closure and latching, making sure that the interlock
safety switches are depressed.
3.16 Initial Startup and Preliminary Test
Warning
Before applying power to any part of the system, carefully read and observe at all times the safety instructions in the
Safety section in this manual.
Refer to the guidelines below upon initial startup and preliminary testing.
96A0461, Rev. H, 2019/10/31 21
Copyright
©
ADB Safegate, All Rights Reserved