Adaptec AAA-130U2 SERIES, Руководство по оборудованию, Страница: 53 / 82

5-3
Installing the Software Driver for Novell NetWare
3
Edit the config.sys file to include command lines for
aspi8u2.sys and aspicd.sys . The following sample command
lines for the config.sys file are appropriate for most systems:
device=c:\scsi\aspi8u2.sys /d
device=c:\scsi\aspicd.sys /d:aspicd0
Note:
For non-Ultra2 systems, use aspi8dos.sys
instead of aspi8u2.sys in the command line (for exam-
ple, device=c:\scsi\aspi8dos.sys /d).
4
Edit the autoexec.bat file to include a command line for
mscdex.exe (the mscdex . exe file is included with MS-DOS 6.x
and above) . The following sample command lines for the
autoexec.bat file are appropriate for most systems:
c:\dos\mscdex.exe /d:aspicd0 /M:12
(This assigns the CD-ROM the next available drive letter, typi-
cally D if there is only one DOS drive.)
5
Reboot the system to the DOS partition.
6
Insert the NetWare CD in your CD-ROM drive.
7
Go to the CD-ROM drive.
8
Type Install and press Enter.
9
Follow the procedures in your NetWare documentation for
installing a new server.
10
If prompted to load an SMP Module, select No. (The SMP
Module can be installed once NetWare is up and running.)
11
When a screen appears that asks you to select a disk driver,
press Enter.
12
Press Insert to install an unlisted driver.
13
Insert the Adaptec Array1000U2 Family Manager Set driver
disk into your floppy disk drive.
14
Press F3 and specify the path to the cda1000h.ham driver. For
NetWare 4.1, the driver is located in \netware\v4_1x on the
disk. For NetWare 4.2, the driver is located in \netware .