5-11
UnixWare Installation
[xxxxx015] Error issuing command
An error has occurred with the driver. Try installing the most up-to-
date version of the driver available from the Adaptec Web site.
[xxxxx020] Adapter or target device not responding or not connected
The target device did not respond to the adapter. If the device is
present, refer to your host adapter’s user’s guide for
troubleshooting information. If the device is no longer connected to
the system, ignore this error.
[xxxxx021] Target device protocol error
An unexpected event occurred during data transfer between the
adapter and target device. Normally, this indicates a faulty or non-
compliant target device.
[xxxxx022] Adapter or target device protocol error
The adapter or target device has broken the communication
protocol. A badly behaving device could cause this message to
appear. Normally this is not a serious problem. If you get this
message frequently over a short period of time, it could indicate that
the device or system is malfunctioning. Unplug or power down
unused devices to see if the problem persists.
[xxxxx023] Target device parity error
The driver has detected a parity error by the target device. Try
decreasing the transfer rate or disable the Ultra SCSI speed in
SCSISelect
®
. Also, make sure you are using good quality SCSI cables.
[xxxxx024] Data overrun or underrun
The adapter was given more or less data than was expected.
[xxxxx030] Target device busy
The target device reports a Busy status. Another program might
already be using this device.
[xxxxx031] Target device queue full
The target device internal buffer is full.
[xxxxx032] Target device busy
The target device reports a Busy status. Another program may
already be using this device.
