5-2
Ultra160 Family Manager Set User’s Guide
Installing the Driver When Installing UnixWare
To install either the
adst21
or
adst70
driver at the same time you
install UnixWare, follow the instructions below. The procedures are
the same for UnixWare 2.1x and 7.01/7.1.
1
Insert the Install disk of the UnixWare package into the boot
floppy disk drive. Reboot your computer.
Wait for the first UnixWare installation screen and prompt to
appear, then follow the on-screen instructions.
2
When prompted to either
Install Host Bus Adapter Drivers
or
Continue Installation
, first remove the Install disk, then select
Install Host Bus Adapter Driver
and press Enter.
3
Insert the Ultra160 Family Manager Set disk for UnixWare 2.1x
or 7.1 into the primary floppy disk drive and press Enter (you
cannot load drivers from a secondary floppy disk drive).
As the driver loads, a message identifying the installed host
adapter briefly appears on screen. The installation process
determines which device drivers on the disks are needed.
4
If you have additional HBA disks, insert the next HBA disk,
select Install Another HBA Disk, and press Enter.
If all of your HBA disks have been installed, remove the last
HBA disk, select Continue Installation, and press Enter.
5
If necessary, enter the DCU (Device Configuration Utility) to
view/change the UnixWare device driver configuration data.
6
Follow the on-screen instructions to continue with installation.
Refer to the UnixWare documentation and on-screen help files
for help in selecting options.
Note:
If your installation fails, do not attempt to use the
update installation
pkgadd
procedure to fix the installation.
Follow the instructions in the UnixWare documentation and
in this User’s Guide to retry the installation.
