Adaptec 2100S - SCSI RAID Controller, Быстрый старт, Страница: 38 / 40

37
IRQ and Address values may be required during installation of
your operating system.
3
Create disk arrays.
Array Groups can be created or modified at any time after system
installation. However, if the boot device will be an array, that array
must be created and built before the operating system is installed.
4
Exit SMOR when you are finished with the configuration tasks.
Arrays that were created or modified start building at this time. For
large arrays, this process may take several hours. You can perform
other activities on the system while the build operation continues.
The array groups being built can be accessed while the build is in
progress. However, access time will be slower until the build is
complete.
If you exit SMOR and you want to monitor the progress of the build
operation, you can use Storage Manger Pro or Storage Manager to
monitor the progress of the build. For additional information see the
Storage Management Software User’s Guide .
The CD-ROM boot utility can create a bootable floppy disk that will
run SMOR. This disk boots DOS and automatically starts SMOR. This
lets you perform configuration tasks if you are unable to start SMOR
from the SCSI RAID controller using
Ctrl+A .