Adaptec 2100S - SCSI RAID Controller, Быстрый старт, Страница: 37 / 40

36
Using Storage Manager on ROM (SMOR)
To configure your hardware and create disk arrays when Storage
Manager is not available, run Storage Manager on ROM (SMOR)
during the system boot. This is especially useful for a new system
where you need to create disk arrays before you install the operating
system.
After configuration of your storage subsystem, install your operating
system according to the procedures in the
SCSI RAID Installation Guide
for your controller. For access to all of the advanced features of your
controller, install the version of Storage Manager Pro or Storage
Manager supplied for your operating system.
Follow these steps to run SMOR and configure a new system:
1
Press
Ctrl+A
when the Adaptec I
2
O BIOS message appears during
boot to start SMOR.
2
Inspect the hardware configuration as shown by SMOR.
a
Verify that all peripheral devices and controllers are shown. If
any devices are missing from the display, exit SMOR and check
your hardware connections.
b
View the Information window for each controller to verify that
all installed expansion and memory modules are shown. Note
the IRQ and Address displayed in the Configuration tab. The