Adam Equipment WBW 16/35a, Краткое руководство

Страница: 7 / 16

P a g e
5
© Adam Equipment Company 2009
5.0 ERROR CODES
During the initial power-on testing or during operation, the scale may show an error message. The meaning
of the error messages is described below.
If an error message is shown, repeat the step that caused the message. If the error message is still shown
then contact your dealer for support.
ERROR
CODE
DESCRIPTION POSSIBLE CAUSES
Err 4 Err 4 Err 4 Err 4
Initial Zero is greater than
allowed
(4% of maximum
capacity) when power is turned
on or when
[Zero] is pressed.
Weight on the pan when turning the scale on.
Excessive weight on the pan when zeroing the scale.
Platform is not installed.
Improper calibration of the scale.
Damaged load cell.
Damaged Electronics.
Err 6 Err 6 Err 6 Err 6 A/D count is not correct when
turning the scale on. Load cell is damaged.
Electronics is damaged.
Err 8 Err 8 Err 8 Err 8 High limit input error Low limit is set first, then the high limit is set lower
than the low limit and high limit not equal to zero.
Err 9
Err 9 Err 9
Err 9 Low limit input error High limit is set first, then the low limit is set higher
than the high limit and low limit not equal to zero.
FAIL H or
FAIL H or FAIL H or
FAIL H or
FAIL L FAIL L FAIL L FAIL L
Calibration error Improper calibration (should be within +10% of the
factory calibration). The old calibration data will be
retained until the calibration process is complete.