Adam Equipment CCEU-20, Руководство пользователя

Страница: 44 / 48

42 | P a g e © Adam Equipment Company 2017
7.0 ERROR MESSAGES
When power is first applied to the scale the software does a self check and
then verifies the voltages from the load cell are acceptable. The display will
show error messages if the voltage is not within certain limits. If these error
messages appear contact your supplier for assistance.
ERROR
CODE DESCRIPTION POSSIBLE CAUSES
Err 1
Error setting a date Trying to set a date that is not
realistic.
Err 2
Error setting time Trying to set a time that is not
realistic.
Err 4
Initial Zero is greater than
allowed (typically 4% of the
maximum capacity) when
power is turned on or when
the
[  Z/T  ] Esc key is
pressed,
Weight is on the pan when
turning the scale on.
Excessive weight on the pan
when zeroing the scale.
Improper calibration of the
scale.
Damaged load cell.
Damaged Electronics.
Err tYPE
Tokens are not allowed to be
added to memory. Shown when trying to add
tokens to accumulation
memory.
SPAn FAIL HI
SPAn FAIL Lo
Calibration Error Will show Hi or Lo if the
calibration mass is too large or
small to allow correct
calibration.
FAIL
Password failed Password was not correct.