Adam Equipment AZextra 15, Руководство по обслуживанию

Страница: 14 / 28

© Adam Equipment Company 2007
12
The parameters available are:
F1 CAL
To enter the Calibration
F2 rES
Resolution selection
F3 Unit
Select kilograms or pounds
F4 CAPA
Select capacity
F5 Point
Unit Price/Price decimal point
F6 init ZEro
Initial Zero Range
F7 rE ZEro
Re-Zero range
F8 SCSivE tArE
Successive Tare Enable
F9 Ad CoUnt
Display the A/D counts
F10 roUnd
Rounding off the Total Price
F11 ZEro
Select the zero mode
F12 Lvd modE
Low voltage detection
6.2.1
F1
-CALIBRATION
To enter the calibration parameter, press the [Tare] key when “
F1
” is displayed.
The display will instruct you to remove any weight from the scale, “
UnloAd
”. Press [Tare] .
The display will tell you to add weight to the scale: “
LoAd
” “
15
” “
kilo
”
Add the weight shown, wait for stability then press the [Tare] key.
The display will show “
SPAn
” “
PASS
” if the calibration is OK. Or it will show “
SPAn
” “
FAIL
” if
calibration could not be completed correctly.
The display will then show “
JP
” “
On
” showing the jumper is still in place. Remove the
weight. Switch off the scale and switch it on again to continue with the other Service
parameters.