ACV International
11
Installing the appliance
1.
Unpack the appliance.
2.
Check the contents of the packaging; the consist of:
•
Appliance (A)
•
Suspension strip (B)
•
Siphon (C)
•
Installation instructions
•
Operating instructions
•
Warranty card
3.
Check the appliance for possible damage: report damage immediately to the
supplier.
4.
Check whether the compression rings are sitting squarely in the mounting
bracket couplings.
5.
Fit the appliance, sliding it downwards over the suspension strip. Ensure at the
same time that the pipes slide into the compression fittings.
6.
Tighten the compression fittings on the mounting bracket. The nipples must not
be allowed to turn!
7.
Open the display cover and unscrew the two screws behind. Then remove the
front panel.
8.
Fit the flexible tube to the siphon outlet.
9.
Fill the siphon with water and slide it as far as possible upwards on to the
condensate drain connector (C) below the appliance.
10.
Connect the flexible tube (A) from the siphon (where applicable together with the
overflow pipe from the inlet assembly and the pressure relief valve) to the drain
via an open connection (B).
11.
Fit the air supply and the combustion gas flue. (See section 5.6)
12.
Place the front cover and tighten the two screws (hand tight), close the display
cover.
C
Clo
IMPORTANT
The Kompakt HRE eco 40 Solo is only to be used in
combination with the accompanying siphon .
Make sure that, when replacing the siphon the correct
version is ordered (art. nr. 91844787)
4.2.3
Fit the cover plate
Hang the flanged upper edge of the cover plate on the washers under the base of the
appliance and slide the cover plate as far as possible towards the rear.
