ACUVANCE XARVIX XX, Руководство пользователя

Страница: 10 / 12

18 19
TUNING THE DRIVING EXPERIENCE
Commentary
This determines the motor rpm at which the boost will begin to operate. As this rpm
value is set lower, boost will operate from a lower speed/rpm point.
⑫
In the select mode with the blue LED flashing 4
times, press the SET button for 2 seconds or more
to enter the setting mode. Each time the SET
button is pressed once, the LED pattern changes
and the boost start rpm value changes as shown
on the right. Adjust the LED to the setting of your
choice and press the SET button for 2 seconds or
more. The set value is validated and it returns to
select mode. The changed value will be reset if the
power is turned off without saving. Please save
your settings before tunring your unit off (P.20).
5,000rpm
10,000rpm
15,000rpm
20,000rpm
Caution
When set low, it is necessary to lighten the drive load and adjust your gear ratio.
Commentary
This determines the motor rpm at which the boost will end. As this rpm value is set
higher, boost will operate to a higher speed/rpm point.
⑬
In the select mode with the red LED flashing 4
times, press the SET button for 2 seconds or more
to enter the setting mode. Each time the SET
button is pressed once, the LED pattern changes
and the boost end rpm value changes as shown
on the right. Adjust the LED to the setting of your
choice and press the SET button for 2 seconds or
more. The set value is validated and it returns to
select mode. The changed value will be reset if the
power is turned off without saving. Please save
your settings before tunring your unit off (P.20).
15,000rpm
20,000rpm
30,000rpm
40,000rpm
50,000rpm
Caution
Please make sure to set the boost end rpm higher than the value of your boost
start rpm. The sudden jump in timing may overload the ESC, therefore it is advised
to start with a much higher boost end rpm and progressively lower timing as you
get comfortable with your gearing.
Commentary
This determines the amount of turbo timing added at full throttle.
⑭
In the select mode with the green+red LED
flashing 4 times, press the SET button for 2
seconds or more to enter the setting mode. Each
time the SET button is pressed once, the LED
pattern changes and the full turbo timing value
changes as shown on the right. Adjust the LED to
the setting of your choice and press the SET
button for 2 seconds or more. The set value is
validated and it returns to select mode. The
changed value will be reset if the power is turned
off without saving. Please save your settings
before tunring your unit off (P.20).
0deg
12deg
20deg
30deg
Important
When using both boost and turbo function at the same time, make sure the total
value of full boost timing and full turbo timing are less than 60°
Commentary
This function limits the output of the motor so that the rpm does not exceed the set
value.
⑮
Boost start rpm (blue flashing 4 times)
Boost end rpm (red flashing 4 times)
Full turbo timing (green+red flashing 4 times)
Rev-Limiter rpm (blu+red+org flashing 4 times)
In the select mode with the blue+red+orange LED
flashing 4 times, press the SET button for 2
seconds or more to enter the setting mode. Each
time the SET button is pressed once, the LED
pattern changes and the rev-limiter rpm value
changes as shown on the right. Adjust the LED to
the setting of your choice and press the SET
button for 2 seconds or more. The set value is
validated and it returns to select mode. The
changed value will be reset if the power is turned
off without saving. Please save your settings
before tunring your unit off (P.20).
OFF
15,000rpm
30,000rpm
50,000rpm