2954 Rubidoux Blvd.
Riverside, CA 92509
Page 3
For questions: [email protected]
Troubleshooting:
If you are at Step 7 above and are never seeing the “AGI_BOARD_XXX” (XXX is any combination of
characters), the WIFI board may need to be refreshed back to factory settings. This will force it back to
setup mode.
1.
Remove the cover of the WIFI module.
2.
With power ON, press and release the RST button.
3.
Immediately press and hold the CLS button until the 3 LEDs on the board are all ON together (as
shown).
4.
Release the CLS button after all 3 LEDs are on together, the board will restart, removing any
network configuration settings it already had.
5.
You should now be able to go back to step 7 above and continue.
