2954 Rubidoux Blvd.
Riverside, CA 92509
Page 2
For questions: [email protected]
17.
After approximately one minute, your smart device will timeout on the connection to the Wi-Fi
board, exit the browser and verify that you are reconnected to your local Wi-Fi network.
NOTE:
You must be connected to your Wi-Fi network for all steps below to work. Make sure
your smart device is connected to your local Wi-Fi and NOT the AGI_BOARD_XXX network.
18.
Check your email on your smart device (phone, tablet or computer) for a new registration email
message (this may take a few minutes).
NOTE:
Check your SPAM and Junk email folders to make sure this message did not get flagged
as spam or junk.
19.
The received email has a message to “Please follow this link for registration”. Press “this link”
to take you to a webpage where you will enter the name of your spa. Enter the name you want
to identify the spa with (no more than 8 characters, no spaces). For example, ‘SPA11’.
20.
Press the “REGISTER” button on the webpage to connect the Wi-Fi control to your spa.
21.
After pressing “REGISTER”, wait approximately 1 minute, then refresh the webpage.
22.
The page should show the name of your spa and some buttons for showing the display, setting
the temperature, and setting the time zone (clock). Any or all of these may already be
expanded to show you the current state of your spa.
23.
Bookmark this page in your browser.
24.
Wait approximately 15 minutes before using the Wi-Fi to allow the control to reset.
25.
To control your spa, open your browser and go to the bookmarked page.
