2954 Rubidoux Blvd.
Riverside, CA 92509
Page 1
For questions: [email protected]
IMPORTANT: When mounting the WF-100 Controller inside your spa cabinet, the water in your spa
can block the radio signals between the WF-100 and your Wi-Fi router. Be sure to mount the WF-100
so that the spa’s water is not between the WF-100 and your Wi-Fi router.
Connect to Acura WF-100 Wi-Fi Controller
1.
Turn your Spa OFF.
2.
Disconnect spa side control panel from side of control.
3.
Open Wi-Fi control box and connect spa side control to connection inside Wi-Fi control box.
4.
Connect Wi-Fi control box cable to spa side control panel connection on the Control.
5.
Turn your Spa ON.
6.
On your smart device (phone, tablet or computer); choose Wireless Networks/WIFI.
7.
Scan available networks for “AGI_BOARD_XXX” (XXX is any combination of characters).
8.
Select “AGI_BOARD_XXX” network, your smart device will connect to Wi-Fi board’s network.
9.
Open a web browser (Chrome, Internet Explorer or Edge only). Type 192.168.1.3 into the web
browser’s address bar.
(192.168.1.3 is your WIFI board’s local network address).
NOTE:
Make sure that there is nothing else in the address (the browser may put // before the
address, this is wrong). You should see only 192.168.1.3, NOT //192.168.1.3!
10.
A web page will open with a large button “Display Scan Results.” Push this button.
11.
Below the button, a list of available Wi-Fi networks will be shown. From this list, select your
local network (A check will appear to the right of your chosen network). After selecting your
network from the list of available networks, scroll down and verify that your networks SID
(name) is shown.
12.
In the “Password” field, enter your local networks password (or WEP Key).
13.
Enter your email address in the “Email Address” field.
14.
Re-enter your email address (for verification purposes).
15.
Scroll down to the “ACCEPT” button and press it.
16.
A new information page showing your network information and your email address will appear.
Verify that the information is correct and then press the “JOIN” button.
