E1/T1 PCI card installation guide
16
Appendix B: USA/Canada Approval Details
This section applies only to the 100 Ohm T1 version of the PM1/2/4 Line Interface Module.
FCC Connection Requirements
This equipment complies with Part 68 of the FCC Rules and the requirements adopted by the
ACTA. The card has a label attached that contains, among other information, the product
identifier in the format US:AAAEQ##TXXXX for this equipment. If requested to do so, you must
provide this information to your telephone company.
Before connecting the card to the public network, you must inform the local Telephone
Company of the following information:
Service Type
SOC
FIC
USOC
T1 6.0N
04DU9-1SN
NA
ISDN (PRI)
6.0N
04DU9-1SN
NA
An FCC compliant modular telephone jack is provided with this equipment. The equipment is
designed to be connected to the telephone network, or premises wiring, using a compatible
modular plug that is Part 68 compliant. See installation instructions for further details. This card
has been assessed against UL60950-1 and is listed accessory component under file number
E178354. UL recommend that this card is installed into a UL listed/recognized system.
If your telephone equipment containing the T1 Digital Access Card causes harm to the telephone
network, the telephone company will notify you in advance that temporary discontinuance of
service may be required. If advance notice isn’t practical, you will be notified as soon as
possible. You will be advised of your right to file a complaint with the FCC if you believe it is
necessary.
Your telephone company may make changes in its facilities, equipment, operations, or
procedures that could affect the operation of your equipment. If they do, you will be given
advance notice to give you an opportunity to maintain uninterrupted service.
If you experience a problem with the E1/T1 PCI card, please contact Aculab USA Inc for
repair/warranty information. Contact details for all Aculab offices are available from the
company web site at
http://www.aculab.com
.
There are no user serviceable components on the card.
UL Requirement
This card has been assessed against UL60950-1 and is a listed accessory component under UL
file number E178354. The E1/T1 PCI card may only be installed in a UL listed PCI bus, based
computer system.
Industry Canada Warnings
The Industry Canada Label identifies certified equipment. This certification means that the
equipment meets telecommunications network protective, operational and safety requirements
as prescribed in the appropriate Terminal Equipment Technical Requirements document(s). The
Department does not guarantee the equipment will operate to the users satisfaction.
Before installing this equipment, users should ensure that it is permissible to be connected to the
facilities of the local Telecommunications Company. The equipment must also be installed using
an acceptable method of connection. The customer should be aware that compliance with the
above conditions may not prevent degradation of service in some situations.
A representative designated by the supplier should co-ordinate repairs to certified equipment.