9
4.1 How does the remote control work
When a command is given, the LED
’
s will indicate the signal
was received.
-
LED 2 on the control box will momentarily flash orange, as an
input signal is received either from a FOB or a switch.
-
LED 1 will start to flash green as 32 VDC is sent to the motor
LED indicator
4.2 Programming remote control
2
1
1.
When the power is turned on by connecting
the battery cable to the control box, within 5
seconds, press the button 1 and 2 at the same
time. The system will then enter the code learn-
ing mode. The UNLOCK OUTPUT will trigger to
remind you that the system is in code learning
mode.
2. Within 5 seconds after entering the code
learning mode, press any button on the trans-
mitter. The UNLOCK OUTPUT will trigger to tell
you the transmitter has been recognized and is
compatible with the system. A maximum of 12
transmitters can be coded per system.
3. During code learning, if there is no action
after 5 seconds, the system will exit learning
mode. The UNLOCK OUTPUT will be the remind-
er.
4. If old FOBs have to be erased from the re-
ceiver
’
s memory for any reason, program the
new FOBs with the above procedure and don
’
t
include the old FOBs in this procedure. This
process will erase the old FOB data from the
receiver
’
s memory.
DoorLIFT DL
-
6
Remote door system
Owner
’
s manual
Note:
if the FOB battery
has to be replaced for any
reason, the battery is a 12
Volt A
-
23 dry cell type
