3
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
•
UV Light in operation; do not operate unless the unit is completely and
correctly assembled; failure to follow warnings may result in
severe eye damage and electrical shock
•
To prevent damage to the unit, operating environment temperature must
never exceed 200
o
F (93
o
C)
•
To reduce the risk of electric shock, this equipment may have a grounding
type plug that has a third (grounding) pin; this plug will only fit into a
grounding type power outlet; if the plug does not fit into the outlet, contact
qualified personnel to install the proper outlet; DO NOT alter the plug in any
way
•
This unit is equipped with a universal ballast that operates at nominal
voltages between 120 and 240 VAC, 50/60 Hz
•
To Reduce the Risk of Electric Shock – Do not use in wet or damp locations;
this equipment emits UV-C radiation; Do not locate equipment in any
location allowing direct line-of-sight to vents, returns, or other duct openings
•
DO NOT use this unit with an extension cord
WARNING
Location for Protective Earth Line.
CAUTION
• Wiring and installation of this unit must be done by a licensed HVAC
contractor or electrician; failure to do so will void warranty of the product
• When the unit is installed in a roof mounted HVAC system, the unit must be
protected from the elements
Read this manual in its entirety before using your activTek INDUCT 750/2000.
Keep out of the reach of children.
•
Live voltage may be present
•
Disconnect power at the breaker or fuse panel before servicing unit; always follow OSHA lockout procedures
to prevent accidental exposure to electrical energy
•
If installed near a furnace or where emergency heat coils could raise the temperature inside the plenum, cycle
the AC unit through three full heating cycles assuring that the temperature never exceeds 200
°
F (93
°
C); the
ActivePure
®
Cell must not exceed 200
°
F (93
°
C)
•
If the unit is hard wired, be sure the power to the unit is off; always follow OHSA electrical lockout safety
requirements to prevent accidental release of energy during service or maintenance activities
•
Never attempt to check operation of the ActivePure
®
Cell(s) by direct observation; severe eye damage can
result; use the indicator lamps on the bottom of the ballast only
