7
x2
Modes (A·PURE /
A·PURE x2)
Fan Speed
(5 Levels)
Clean Filter
Assembly
Ion
Operation
Flicker:
Replace ActivePure
®
Cell
Red Light:
ActivePure
®
Cell Malfunction
LED DISPLAY
The LED Screen is used to display all current settings (see
page 6) as well as any maintenance reminders.
If a maintenance reminder or a service reminder appears, the
backlight will brighten and constantly flash until the Reminder
Reset icon is pressed or the service problem is corrected.
When maintenance is required, the Display Screen will brighten and flash and the Maintenance Reminder will appear.
MAINTENANCE REMINDERS
• Unplug the unit before performing any maintenance procedures
• Do not operate the ActivePure Surface & Air Guardian without the Filter Assembly and
Back Cover properly installed
WARNING
PERFORM CLEANING
• The perform cleaning CLEAN indicator will come on approximately every 180 days; for optimal performance, it is
recommended to perform cleaning on your unit every 30 days
• Clean the Filter Assembly (See Page 9)
• Vacuum the ActivePure Cells
• Vacuum Top and Rear Grill openings
NOTE:
Be sure to press the Reminder Reset icon to clear the reminder following regular maintenance (See Page 6)
When the CLEAN indicator starts flashing, it reminds you to clean the filter.
Follow the steps below to remove the filter and clean it. While powered on, hold the Reset button, approximately
three seconds, untilyou hear a beep sound alerting you that it has been cleared.
Hand Strap
1. Unplug unit
2. Press the top of
the back cover to
release the back
panel
3. Lift up to remove
the back panel
4. Use the included
screwdriver to
unscrew the Filter
Assembly
5. Lift the Filter
Assembly up
and out to
remove
