11
REMOVING THE ACTIVEPURE® CELLS
CAUTION
Do not look directly at the glowing lamp. Prolonged exposure, even to reflected UV light,
can cause eye damage according to the American Conference of Governmental Industrial
Hygienists (ACGIH) Standards.
WARNING
• Unplug the unit before performing any maintenance procedures
• Do not operate the ActivePure Surface & Air Guardian without the Filter Assembly and
Back Cover properly installed
NOTE:
Use genuine ActivePure replacement parts only. Parts from anyone other than ActivePure may damage your unit
and void your warranty.
1. Unlock the ActivePure Cell
connector by pressing on
the connector’s locking
tabs.
2. Pull the connector
straight out to
unplug.
3. Remove two (2)
thumbscrews.
4. Slide the ActivePure
Cell down and out of
the unit.
INSTALLING THE ACTIVEPURE® CELLS
WARNING
• Unplug the unit before performing any maintenance procedures
• Do not operate the ActivePure Surface & Air Guardian without the Filter Assembly and
Back Cover properly installed
1. Slide the ActivePure Cell up and
into the unit. Be sure the back lip
of the ActivePure Cell engages
the two slotted protrusions at the
rear of the unit, and that the angle
brackets and studs are correctly
aligned.
3. Press the connector firmly
until the two tabs lock into
place.
5. Use the included screwdriver
to screw in the Filter Assembly
6. Replace the Back Cover by
inserting the bottom in first
and snapping it into place.
2. Insert the two thumbscrews
and tighten. Insert the
ActivePure Cell connector into
the plug at the rear of the unit.
4. Replace the Filter Assembly,
inserting the bottom of the
Filter Assembly first
