31
Mid-size Scooter Series
2
3
1
6
4
5
Follow these easy steps for a quick and safe repair
for solid tires
:
1. Remove the key from the key switch.
2. Elevate the side of the scooter of which you are
removing the tire. Place wooden blocks under the
frame to elevate the scooter.
3. Remove the wheel cap, drive wheel nut and
washer from the axle.
See figure 23
.
4. Pull the wheel off of the axle.
5. Slide the new wheel onto the axle. Make sure the
the axle key is in the axle slot.
WARNING! Ensure that the axle key is
properly installed into the axle slot
when mounting the wheel. If not
installed securely, the braking system
is disengaged which may cause
personal injury and/or product
damage may result.
6. Reinstall the drive wheel nut and washer onto the
axle and tighten.
WARNING! Make sure that both the
nut and washer are reinstalled and
tightened properly.
7. Reinstall the wheel cap.
8. Remove the blocks from beneath the scooter.
V I I I . C A R E A N D M A I N T E N A N C E
Your scooter requires a minimal amount of care and maintenance. If you do not feel confident in your
ability to perform the maintenance listed below, you may schedule inspection and maintenance at your
authorized Provider. The following areas require periodic inspection and/or care and maintenance.
SOLID TIRE SAFETY CHECK
Regularly inspect your scooter’s tires for signs of damage or wear.
WHEEL REPLACEMENT – SOLID TIRES
If your scooter is equipped with solid tire inserts and you have a damaged or worn tire, the entire wheel
must be replaced. Contact your authorized Provider for information regarding replacement wheels for your
scooter.
WARNING! Wheels on your scooter should only be serviced/replaced by a qualified
technician.
WARNING! Be sure that the key is removed from the key switch and the scooter is not in
freewheel mode before performing this procedure.
Figure 23. Wheel Removal
IDENTIFICATION KEY
1. WHEEL CAP
2. DRIVE WHEEL NUT
3. DRIVE WHEEL WASHER
4. WHEEL
5. AXLE KEY
6. AXLE SLOT
