Active Care Medical Mid-size Scooter series, Руководство пользователя

Страница: 24 / 36

24
Mid-size Scooter Series
7
1
3
5
2
4
6
8
4. While holding the upper seat post at that
height, align the adjustment holes of the upper
and lower seat posts.
5. Insert the seat height adjustment bolt through
the locating holes of both the upper and lower
seat posts.
6. Reinstall the nut onto the seat height
adjustment bolt and tighten.
7. Reinstall the shroud and the seat
SEAT HEIGHT ADJUSTMENT—COMFORT
SEAT POST (IF EQUIPPED)
To reposition the seat to one of two different
heights:
1. Remove the seat from your scooter. Push
forward or pull upward and hold the seat
rotation lever to disengage the seat, then rotate
the seat and lift it off of the scooter.
2. Remove the rear shroud.
3. Push up the seat post boot to uncover the
hardware.
4. Push down on the seat post while loosening
and removing the shoulder bolt, washer, and
nut. See figure 17.
5. Remove the comfort spring.
6. To raise the seat to the top most mounting hole,
insert the height adjustment spacer. To lower
the seat to the lowest mounting hole, remove
the height adjustment spacer.
Figure 17. Seat Height Adjustment - Comfort Seat Post
V . C O M F O R T A D J U S T M E N T S
7. Reinstall the comfort spring.
8. Hold the upper seat post at the desired height and match up the locating holes in the lower seat post.
Utilize the top holes for the upper position or the bottom holes for the lower position.
9. Press down on the seat post while reinstalling the hardware and tightening to 210 in • lb (24 N • m).
10. Replace the rear shroud and the seat.
SEAT SUSPENSION ADJUSTMENT (IF AVAILABLE)
You can loosen or stiffen the seat suspension based on which comfort spring you install.
To adjust the seat suspension:
1. Remove the seat from your scooter. Push forward or pull upward and hold the seat rotation lever to
disengage the seat, then rotate the seat and lift it off of the scooter.
2. Remove the rear shroud.
3. Push up the seat post boot to uncover the hardware.
4. Push down on the seat post while loosening and removing the hex head bolt and nut.
5. Remove the current spring.
6. Install the desired spring. See figure 17.
7. Press down on the seat post while reinstalling the hardware and tightening to 210 in • lb (24 N • m).
8. Replace the rear shroud and the seat.
IDENTIFICATION KEY
1. BOOT
2. UPPER SEAT POST
3. COMFORT SPRING
weight c
a p a cities: 0-220 l b s. (0-90.72 kg)
220-400 l b s. (90.72-181.44 kg)
4. SPACER
5. SHOULDER BOLT (210 in • l
b [24 N • m])
6. LOWER SEAT POST
7. WASHER
8. NUT