actionair ESP PLATINUM ERQ2-14AS, Инструкция по установке и наладке

Страница: 12 / 16

Installation & Commissioning Guide - ESP Platinum ID Split Ducted Units
Doc. Part No. 0525-052 Rev. 4.0 180302 Page 12 of 16
MAXIMUM CABLE LENGTHS
R
®
NOTE:
DIAGR AM SHOWN ABOVE IS A GENERAL PRESENTATION ONLY. REFER TO INDIVIDUAL UNIT WIRING DIAGRAM
FOR COMPLETE WIRING CONNECTION DETAILS.
ITEM DESCRIPTION MAXIMUM CABLE LENGTH *
1 to 2 Outdoor PCB to Indoor PCB 60 m
2 to 3 Indoor PCB to Ultima Module (factory fitted) 0.175 m
2 to 4 Indoor PCB to Master Wall Controller 30 m
2 to 4A Indoor PCB to Secondary Wall Controller 30 m
Suggested Maximum Cable Length
Long runs beside Mains cables or TV antenna cables should be avoided where possible.
*
OPTIONAL
DUAL MASTER CONTROLLER
(Mimic Logic)
Master Controller Secondary ontroller
4
4A
Cat5E spec cable with RJ45
connector and cable boots - Yellow
FIELD WIRING BY INSTALLER
2 CORE 7/0.30 (0.5mm
2
) Twisted Pair Shielded Data Cable
with Screen Foil clamped to a Metal P-Clip.
OUTDOOR UNIT
TO OUTDOOR PCB
MODEL
R-410A
“CAUTION”
PLEASE THERE IS
NO GAS / PRESSURE IN THE FAN COIL UNIT BEFORE
REMOVING COPPER END CAPS.
ENSURE
3670-043
Sen
sor
4
CAUTION
LIVE ELECTRICAL WIRING
AUTHORISED TECHNICIANS ONLY
INTERNAL CONTROL ISOLATOR FITTED
MODEL
MEPS
C E R T I F I E D
A
U S T
RA LIAN M
A D E
A U
S T R A
L I AN O
W N E
D
R-410A
1
DIAGRAM SHOWING SCREEN FOIL CLAMPING
Metal P-Clip
Electrical Panel
2 CORE 7/0.30 Twisted Pair
Shielded Data Cable
Outdoor Board
Terminal Plug A&B
Cut-off Data Cable screen wire & clamp screen foil
with metal P-clip unto OD control panel. Ensure
good earth connection with screen foil.
MODEL
R-410A
“CAUTION”
PLEASE THERE IS
NO GAS / PRESSURE IN THE
FAN COIL UNIT BEFORE
REMOVING COPPER END CAPS.
ENSURE
3670-043
Sen
sor
4
CAUTION
LIVE ELECTRICAL WIRING
AUTHORISED TECHNICIANS ONLY
INTERNAL CONTROL ISOLATOR FITTED
MODEL
MEPS
C E R T I F I E D
A
U
S T RA
LIAN M
A
D E
A
U S
T RA
L IAN O
W N
E D
R-410A
INDOOR UNIT
2
8 ZONE
MODULE
3
TO INDOOR PCB
Trace wire connects to SCN
on ID PCB, keep as short as
possible. Do not connect to
Wall Controller.
Maintain twist in cables all
the way to connector