
2.
Slide the assembled Support Pole (B & C) done in step 1
into the Foam Sleeve (F). Cover the entire area of the
Support Pole’s Foam. (See Fig.2).
3.
Insert the Ball Cap (F) over top of Upper Support Pole.
Align holes and fasten the Ball Cap (F) to the assembled
Support Pole using Ball Cap Screw (E). (See Figure 3)
4.
Place one of each assembled Support Pole done in step 3 at
every leg of the Trampoline. One adult can support the pole
in an upright position while the other adult attaches the
u-bolts. Place the U-Bolt Spacer (I) in between the Leg
Tube and the Support Pole. Using the U-Bolts x 2 (G), place
around the support pole and then slide on the U-Bolt Clamp
(H) over the Leg Tube. Fasten the U-Bolt Clamp using the
Dome Nut (J) (See Figure 4). Before tightening, ensure the
screw ends of the u-bolt are on the inside of the trampoline
and the curved end of the u-bolt is on the outer side of the
unit. The Support Poles should reach the base of the
Trampoline Legs. Once the assembly has been completed
properly, the Support Poles should look like Figure 5. If
possible use an electric screwdriver to assist.
Net Assembly
1.
Stretch Net Assembly (A) out. Locate the panel with the
doorway and align the net as to where you would like to get
in and out of the trampoline. The edge with the pre-sewn
hanging loops is the top of the net. Working your way
around the unit, place each hanging loop over the top of
each ball cap (See Figure 1).
©
ACTION SPORTS EQUIPMENT PTY LTD – www.actionsports.com.au
Page: 20