Flash one time for 3s
GSM signals and SIM card
are normal
3
Installation of Panel
3.1
Alarm Panel Initial Setup
Load the SIM Card, connect telephone line, fix the GSM Antenna, connect the power and other
cables if any, then power up alarm panel. The alarm panel voice prompt "Welcome to use alarm
system", and start self-test the GSM network, “GSM Signal indicator ” flash one time each 1s
means it's searching the GSM signals ,when“GSM Signal indicator ” flash one time each 3s
means GSM signals and SIM card are normal.( it takes about 10 seconds or so for
searching).Remark : if all defence zone indicating light(6) is flashing and the alarm panel restart
for 20s means Unloaded SIM card or loaded wrong.
Upon everything working properly, the battery switch should be at the [ON] position for
continuous charging.
3.2 Pre-record Voice Message
Alarm panel will play a pre-recorded voice message after the alarm call when a pre-set phone
number upon alarm. To record customized message:
Press and hold "SET"Key 3s to enter the configuration mode:
Speak your message at the panel for recording
System will record 10 Seconds and then automatically exit; or press any key to end
whenever your message end.
Press"SET"Key to exit setup status.
3.3 Enable or disable the GSM Module:
System default the GSM module is on . if the user not installed the SIM card , the host will
restart until find SIM card and GSM signal.
Remark:
If set the GSM module to off, the alarm system only used as the live alarm
system,only cleared the police , can not dialed the phone alarm number.Moreover ,the host
without the SIM card would not restart when you closed the GSM module.
3.3.1 Close GSM module method:
● In the disarm status, press [
SET
] key for 3 seconds, release it when the recording light on .
● Wait 2seconds, and then hold the [
SET
] key 3 seconds once again, the panel will respond
with "di ,di,di" three times means changing into the state of closed the GSM module .
● Turn on the power supply again after power off . the panel will prompt "welcome to use alarm
system ", and "di di di" three times ,means the GSM module is off.
3.3.2 Open GSM module method:
● In the disarm status, press [
SET
] key for 3 seconds, release it when the recording light on .
● Wait 2seconds, and then hold the [
SET
] key 3 seconds once again, the panel will respond
with " di,di" twice means changing into the state of open the GSM module .
● Turn on the power supply again after power off . the panel will prompt "welcome to use alarm
system ", and "di" once ,means the GSM module is on.
Remark:If the GSM module is off,the alarm system would be can not read the SIM card .
Содержание AC3828
Страница 1: ...GSM SECURITY ALARM SYSTEM User Manual ...
