www.acti.com
ENR-2000 Series System Administrator’s Manual
20
Install the Hard Disks
This system requires at least one hard disk to store video recordings and firmware image
when upgrading system. Please follow the instructions below to install your hard disks in
correct order to make sure the physical disk locations accord with the
Disk ID
shown in ENR
server’s
Storage Device List
.
To start,
TURN OFF THE DEVICE
, open the front
cover, repeat the following steps to install the hard
disks into the disk bays.
Step 1 Remove the Tray
Slide the
Lock Tab
to the right, the
Hinge Tab
will
pop out by itself. Remove the four front panel screws,
and then remove the three back panel screws.
Pull the
Hinge Tab
to 90 degrees from the front, and
pull out the tray.
