ACS ALCOLOCK LR, Руководство по установке

Страница: 57 / 72

Installation Manual
56
1. Press OK to proceed.
If the speed is correct,
Turn Off Engine
is displayed.
2. Turn the key to the off position. (Press Cancel to return to the
Removal menu.)
Skip section 22.3.3 and continue to section 22.4 to input the
odometer reading.
22.3.3 No OBD
NOTE: Read this section for non-hybrid vehicles where the tach was
not obtained through OBD-II.
After selecting the NO OBD option in section 21.2 “OBD
Select”, TACH is displayed, along with the following:
• Idling – the vehicle engine rpm reading
If the “Idling” rpm reading is lower than the “Idle Point” rpm
value on the second line, “Stopped” will be displayed instead
of “Idling”.
If the “Idling” rpm reading is higher than the “Run Point” rpm
value on the third line, “Running” will be displayed instead of
“Idling”.
If the rpm reading on the first line is not set to “Idling”, check
the tach source and the ECU connection. A new tach source
may be required.
If the problem continues, obtain the tach signal using a
digital tach sensor (DTS). The ECU or HS may need to be
exchanged.
• Idle Point – a preset rpm threshold value
•
Run Point
– a preset rpm threshold value
The initial Idle Point and Run Point values may vary,
depending on the vehicle.