ACS-CONTROL-SYSTEM GmbH
l Lauterbachstr. 57 l D-84307 Eggenfelden l www.acs-controlsystem.de l [email protected]
15
5. Setting up the device
13
Special function [O]-key,
tASt.4:
Default:
no
For the operation mode, special functions can be deposited on the
[O]-key.
This function is
activated by pressing the key.
Set.OF
adds a defined value to the currently displayed value.
EHt.rE
deletes the min/max-memory.
ActuA
shows the measuring value for approx. 7 seconds,
after this the device switches back onto the parameterised display value. If
no
was selected, the
[O]-key
is without any function in the operation mode.
Display flashing,
FLASH:
Default:
no
A display flashing can be added as additional alarm function either to single or to a combination
of off-limit condition. With
no
, no flashing is allocated.
Assignment (deposit) of key functions,
tASt:
Default:
no
For the operation mode, special functions can be deposited on the navigation keys
[
▲
] [
▼
]
, in
particular this function is made for devices in housing size 48x24mm which do not have a 4th
key (
[O]-key
). If the min/max-memory was activated by
EHtr
, all measured min/max-values are
saved during operation and can be recalled via the navigation keys. The values get lost by
restart of the device. If the threshold value correction
LI.12
or
LI.34
is choosen, the values of the
threshold can be changed during operation without disturbing the operating procedure. Under
Light
the brightness can be changed during operation. If
no
is selected, the navigation keys are
without any function in the operation mode.
Back to menu group level,
rEt
:
With
[P]
the selection is confirmed and the device changes into menu group level
„–fct–“
.
Parameterisation level
Menu level
