Step 5: Verify Operation of the SA230P Card
Acqiris SA230P Startup Guide
19
AqMD3Verify
utility checks the version of the Control FPGA firmware. If the version is not
up-to-date, the tool will automatically propose to update the firmware using the firmware
update utility. Once the Control FPGA firmware has been updated successfully, please
power off your computer and restart it again for the update to take effect. You may then
proceed with the
AqMD3Verify
utility as described in this section.
If a Problem is Found
1. Verify that you have made all configuration settings as shown above.
2. Verify that the signal generator is ON and producing the desired signals at the end of the
cable. This can be done with an oscilloscope.
3. Verify that the problem is reproducible.
4. Then, please contact technical support
.
