Step 4: Install the Card
SA230P fan assembly fixing.
SA230P with reversed fan assembly.
1. Remove the four screws (B) nearest
to the front of the fan unit.
2. Carefully, slide the fan unit approx-
imately 15 mm to the rear until it
clears the circuit board, keeping the
fan unit level with the card both hori-
zontally and vertically and rotate the
fan unit by 180°, without dis-
connecting the fan power cables.
3. Slide the fan unit back towards the
card, keeping the fan unit level with
the card both horizontally and ver-
tically, until the card is fully seated
into the support slots.
4. Refit the four screws (B), push the
fan unit upwards away from the cir-
cuit board and tighten the four
screws using 0.5 torque.
5. If the card has a card retainer:
before fitting the card in the retainer,
the screw (A) should be removed
and refit of the oposite side of the
fan, as illustrared on the left.
14
Acqiris SA230P Startup Guide
