25
2.3 Advanced functions
TIMERPROG
Use this function to activate the
TIMER
at a set time every day.
Launch the
TIMER
function and set the timer duration (see section 2.2). Then keep
the button pressed for 5 seconds until the symbol flashes.
The
ON
and symbols will then be displayed.
Your appliance will automatically operate on full power every day starting half
an hour before the time the
TIMERPROG
function was first activated. The time
remaining will scroll across the display until the end of the preset period.
Press the button to exit the
TIMER
function.
will flash to indicate that the Timerprog function is active. To deactivate,
press the
MODE
button until
NO
-
HEAT
mode is selected..
NOTE:
the
TIMERPROG
function will be deactivated if the power supply is interrupted.
CALIBRATING AND DISASSOCIATING THE COMFORT
AND ECO TEMPERATURES
The calibration facility can be used to correct any variation between the room
temperature achieved by the appliance and the setpoint temperature requested
at the thermostat.
To do this, enter the variation between the temperature measured by a
thermometer in the room and the temperature achieved in
COMFORT
mode.
Press the
MODE
button for 5 seconds.
The thermostat will then allow the measured temperature reading to be changed
by up to
+
or
-
5°C in 0.5°C increments by pressing the
+
and
–
buttons..
Then press the
MODE
button to move to the disassociate function.
Press the
+
and
–
buttons to select:
OF
: The
ECO
mode temperature is your chosen
COMFORT
mode temperature minus
3.5°C.
ON
: The
ECO
mode temperature can be set independently of the
COMFORT
mode
temperature by pressing the
+
and
–
buttons.
Press the
MODE
button to exit.
E N
2.2 Basic functions
Select your desired operating mode by pressing the
MODE
button. You can adjust
your room temperature setting by pressing the
+
and
-
buttons (see section 2.1).
TIMER
This function allows you to operate your appliance at full power for a preset
period. Press the button to initiate this function from any mode except
NO
-
HEAT
mode.
The
ON
and symbols will then be displayed.
Press the
+
and
–
buttons to adjust the timer duration in 15 minute increments
to a period of between 15 and 90 minutes.
The time remaining will scroll across the display until the end of the preset
period.
Press the button at any time to exit this function..
ELECTRONIC LOCK
Use of this function prevents any unwanted operation of the keypad.
Press the
+
and
–
buttons together for 5 seconds to lock the keypad and prevent
any inadvertent change of mode or setpoint temperature.
The symbol will then appear.
To unlock, press the
+
and
–
buttons together for 5 seconds.
NOTE:
This function will not block mode change commands from a
Pilot Wire
or
PLC unit
.
F R
24
E N
