Acova ASV-060-090/GF, Инструкция по эксплуатации

Страница: 34 / 45

65
05/2019
64
40019308
After no key has been pressed for one minute , the remote control will automatically
quit the advanced parameters and turn off.
No Parameter Description
Default
setting
Setting
3 Pilot wire Value 0 (pilot wire disabled) or 1 (pilot wire enabled) 1
Press the
+
or
-
key
4 Ambient
temperature
calibration Adjustable from -5.0°C to 5.0°C in 0.5°C steps 0.0
Press the
+
or
-
key
5 Selection of
temperature
sensor Value 1 (receiver unit) or 2 (remote control)
See chapter 5.4
1 or 2
Press the
+
or
-
key
6 None —
7
Re-pairing
radio-
frequency
Value 0 (unpaired command) or 1 (paired command) rF0 or
rF1 Press on + or - key to*
re-pair an appliance
which was
previously
paired but has lost the
link.
8 Default display Value 0 (time) or 1 (temperature setting) 1
Press the
+
or
-
key
9 Display
version
number and
reset
(unpairing). Back to factory settings
Warning!
All your settings as well as the pairing, will be deleted.
If the remote control was paired before the reset, the
receiver unit will also be reset.
x.xx Press on + key for 10
seconds to reset.
End Display
parameter
setting output Quit the settings menu Short press on
mode or for
2 seconds on .
5.3 Advanced parameter setting for remote control
WARNING!
Access to parameter setting is possible only when the remote control is off.
Some parameters on your remote control can be adjusted according to how you use it.
mode
boost
mode
boost
Back to
previous
parameter.
Go to
the next
parameter.
Parameter
number
Parameter
value
No Parameter Description
Default
setting
Setting
0 Duration of
Boost
operation Adjustable from 15 to 120 minutes in 15 minute steps 60
Press the
+
or
-
key
1 Window open
detection Value 0 (function disabled) or 1 (function enabled) 1
Press the
+
or
-
key
2 Eco
temperature Value 0 (eco temperature unlinked) or 1 (linked eco-
temperature setting: comfort T° minus 3.5°) 1
Press the
+
or
-
key
Press on P1P2 and
mode for 2 seconds
to enter.
WARNING
!
It is essential to get
to the final “End” screen, to
confirm your parameter
changes.
mode
boost
2
seconds